Ricoh Aficio SP 4310N Manuals - Page 60
Match the controller board to the top and bottom rail using the, mark, and then slide
View all Ricoh Aficio SP 4310N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
3. Installing Options 3 CEE105 8. Fit the hard disk on the connector of the controller board carefully until it stops. CEE140 9. Tighten the two screws by turning them clockwise with a coin, and then secure the hard disk board by tightening the third screw from the under side of the controller board. CEE141 10. To install other options on the controller board, follow the installation procedure shown in the documentation provided with the option. 11. Match the controller board to the top and bottom rail using the " " mark, and then slide it into the printer slowly until it stops. The printer may malfunction if the controller board is not properly installed. 58
CEE105
8.
Fit the hard disk on the connector of the controller board carefully until it stops.
CEE140
9.
Tighten the two screws by turning them clockwise with a coin, and then secure the hard disk
board by tightening the third screw from the under side of the controller board.
CEE141
10.
To install other options on the controller board, follow the installation procedure shown in
the documentation provided with the option.
11.
Match the controller board to the top and bottom rail using the "
" mark, and then slide it
into the printer slowly until it stops.
The printer may malfunction if the controller board is not properly installed.
3. Installing Options
58
3