Ricoh Aficio SP 4310N Manuals - Page 89
Press the [Escape] key until the screen returns to the [Network] menu., If you use IPv4
View all Ricoh Aficio SP 4310N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
Ethernet Configuration 5. Press the [ ] or [ ] key to select the appropriate network protocol, and then press the [OK] key. 6. Press the [ ] or [ ] key to select [Active] or [Inactive], and then press the [OK] key. Set other protocols you need to set in the same way. • Select [Inactive] for unused protocols. 5 • Enable IPv4 to use the pure IPv4 environment of NetWare5/5.1, NetWare 6/6.5. 7. Press the [Escape] key until the screen returns to the [Network] menu. 8. If you use IPv4, assign the IPv4 address to the printer. Press the [ ] or [ ] key to select [Machine IPv4 Address], and then press the [OK] key. To get the IP address for the printer, consult your network administrator. 9. To specify the IP Address, press [IP Add.]. If you use IPv4, also assign the subnet mask and gateway address. To assign these, press [Subnet M] or [Gateway]. 10. Enter the address, and then press the [OK] key. Change the IP address from "11.22.33.44" to an IP address supported by your network. 87