Samsung NX58R5601SS/AA User Manual - Page 50

Operating the oven NX58*560***, NX58*751*** 2. Press the START/SET pad to begin slow cooking. NOTE • Use only 1 rack and place the rack in position 3 or 4 for the best results. • Preheating the oven will not be necessary. Dehydrate This function is designed to dry food or remove the moisture from food using heat circulation. How to set the Dehydrate function 1. Press the Dehydrate pad. Operating the oven NX58*565*** Air Fry mode (Model NX58*751***) This feature uses hot air for crispier and healthier frozen or fresh foods without or less oil than normal convection modes. For best results, use this mode in single oven mode and place the Air Fry tray in position 3. The temperature can be set between 350 °F and 500 °F. Preheating is not necessary for this mode. Follow recipe or package directions for set temperature, time or quantity. How to set the oven for Air Fry mode 1. Place the tray on rack position 4. 2. Select Air Fry mode using the touch key. 3. Use the touch key to change the default temperature. Enter the suggested temperature for your food as recommended by its instructions. The default temperature is 425 °F. 4. Push the touch key and set the Cook Time or Delay Start, if necessary. 5. Press START/SET pad to start Air Fry mode. 6. When cooking is complete, press OFF/CLEAR pad. take out the food. Air fry tray NOTE Tray or Baking sheet Air Fry Tray recommended placement • Place a baking sheet or tray on the rack below the Air Fry tray to catch any drippings. This will help to reduce splatter and smoke. • Air Fry is designed for baking on a single oven rack. Place food on rack position 4 for best results. 50 English 2. Press the number pads for the desired temperature. (set between 100 ˚F and 175 ˚F) 3. Press the START/SET pad to start the dehydrate mode. 4. When the food is dehydrate, press the OFF/CLEAR pad. NOTE • Do not preheat the oven for this function. • After drying the food, keep it in a cool and dry place. • If the temperature setting is out of range, an error will be displayed.