Sony BVME170A User Manual (Operating Instructions - BVM-E250A / BVM-E170A) - Page 101

Chapter 4 Operations Procedure 1 Select the channel number and set the input signal to display as signal A. 2 Select the display mode of Picture&Picture (Side by Side, Wipe, Butterfly or Blending) with the function button1) of the controller or in the Function Switch menu (page 75) of the Function Setting menu and set it to On. 1) Each function of Picture&Picture is assigned to each function button of the controller in the Function Key menu (page 92) of the Controller menu. 3 Select the channel number and set the input signal to display as signal B. The channel for signal B is set to CH01 at the factory setting. Note When the picture is displayed in wipe, butterfly or blending mode, set signal A and signal B to the input signal of the same signal format and signal system to compare the picture correctly, and set to the native scan mode (page 75). To display the captured picture data file You can use a captured picture other than the picture selected by designating the channel number as signal A and signal B. Instead of setting the channel number in step1 or step3, press the Capture Load button2) or select Load in the Capture menu (page 74) of the Function Setting menu. 2) Capture Load is assigned to the controller in the Function Key menu (page 92) of the Controller menu. Note When the captured picture data file is used in wipe or blending mode, input a 3G/HD-SDI signal for another signal. When a signal not available for capture other than the 3G/HD-SDI signal is input, the picture will not be displayed correctly. To end the multi display Set Side by Side, Wipe, Butterfly or Blending to Off in Function Switch menu (page 75) of the Function Setting menu, or set each function button of the controller to off. Magnifying the Picture (Pixel Zoom) As part of the picture is magnified up to 8 times (up to 4 times when the display magnification of the native scan is ×2) without scaling processing, this is convenient for confirming a minute of the signal. This functions in native scan mode. Note Pixel Zoom is not set to on in the following cases: • When the menu, monitor status page, or list of the functions assigned to the function buttons is displayed • When Side by Side, Wipe, Butterfly or Blending is set to On • When the internal signal is displayed • When the input signal has no sync signal 1 Set Native Scan to On by pressing the NATIVE SCAN button of the controller or in the Function Switch menu (page 75) of the Function Setting menu. 2 Display the picture and set Pixel Zoom to on by pressing the Pixel Zoom button1) of the controller. The cursor is displayed. Note When Native Scan Mode is set to Aspect Correction and Pixel Zoom is set to on for SD signal input, Native Scan Mode is set to ×2. To cancel the cursor display and return to the previous screen Press the MENU button of the controller. 1) Pixel Zoom is assigned to a function button of the controller in the Function Key menu (page 92) of the Controller menu. 3 Select the cursor size with the UP or DOWN button of the controller. You can select the cursor size from 1 to 8 (from 1 to 4 when the display magnification of the native scan is ×2 (page 68)). The larger the number, the smaller the cursor. 4 Adjust the position of the cursor. To move the leftward or rightward: Turn the PHASE knob. To move the upward or downward: Turn the CHROMA knob. 101 Magnifying the Picture (Pixel Zoom)