Sony BVME170A User Manual (Operating Instructions - BVM-E250A / BVM-E170A) - Page 28

Chapter 2 Preparations Connecting the Controller (BKM16R) BVM-E250A DC 5V OUT connector NETWORK switch t Set to PEER TO PEER. LAN (10/100) connector SMF-700, etc. Controller (BKM-16R) DC 5V/12V IN connector LAN (10/100) connector with the controller to the DC 5V/12V IN connector of the controller. Connecting the Multiple Units with the LAN The controller controls up to 32 monitors. Up to four controllers are connected to one monitor in single mode. Note The controller cannot control monitors in another subnetwork. NETWORK switch tSet to LAN. BVM-E250A BVM-E250A LAN (10/100) connector LAN (10/100) connector NETWORK switch tSet to PEER TO PEER. 1 Turn off the MAIN POWER switch of the monitor before connecting the units. 2 Set the NETWORK switches of the monitor and the controller to PEER TO PEER. 3 Connect the LAN (10/100) connector of the monitor and the LAN (10/100) connector of the controller by using the SMF-700 or the cable supplied with the BKM-37H/38H, or a 10BASE-T/100BASE-TX straight LAN cable (shielded-type, optional). Note When an optional LAN cable is connected, use a shielded-type cable to prevent a malfunction due to noises. 4 Connect the DC 5V OUT connector of the monitor and the DC 5V/12V IN connector of the controller by using the SMF-700 or the cable supplied with the BKM-37H/ 38H. Or connect the output cable of the AC adaptor supplied AC adaptor (supplied with the BKM-16R) Switching hub (recommended: with AUTO MDI/MDI-X function) Controller (BKM-16R) DC 5V/12V IN connector LAN (10/100) connector NETWORK switch tSet to LAN. 1 Turn off the MAIN POWER switch of the monitor before connecting the units. 2 Connect to the network by using a 10BASE-T/ 100BASE-TX cable (shielded-type, optional). 28 Connections (BVM-E250A)