Sony BVME170A User Manual (Operating Instructions - BVM-E250A / BVM-E170A) - Page 141
Symptom, Assumed causes, Remedy, Set Over Range to Off in the On Screen Set menu
View all Sony BVME170A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 141 highlights
Symptom Assumed causes Remedy The function button of the controller does not function. The setting has been changed in the The last setting becomes effective. menu after setting with the function button. The function of the function button Another function has been assigned to See the Function Key menu (page 92) of the of the controller is different from the button. Controller menu to confirm the function assigned to that of the panel display. the function button. The Gamut Error message does not go off. A gamut error is detected. OSD Notification Reset is set to Manual and the detected error information is remained. • Set Gamut Error Display to Off in the Gamut Error Display menu of the Function Setting menu (page 72). • Set OSD Notification Reset to Auto in the Gamut Error Display menu of the Function Setting menu (page 73). • Press the function button that the Error Notify Clear function is assigned in the Function Key menu of the Controller menu (page 94). • Set the pin of the PARALLEL REMOTE connector that the Error Notify Clear function is assigned in the Parallel Remote menu of the System Configuration menu to On (page 82). • Select Error Notify Clear in the Function Switch menu of the Function Setting menu (page 79). The zebra pattern does not go off. A gamut error is detected. Set Gamut Error Display to Off in the Gamut Error Display menu of the Function Setting menu (page 72). An Over Range error is detected. The zebra pattern is set to be displayed in the Over Range portion, and the detected Over Range information is retained. Set Over Range to Off in the On Screen Set menu of the System Configuration menu (page 84). Note If the OVER RANGE lamp lights, adjust the contrast or brightness to a lower level. The picture is not displayed on the monitor when you have connected two or more computers via the DisplayPort connector through a switch box or other device and switch the input signal from one computer to another. You have switched from a computer that is in power save mode to another. Do not switch from a computer in power save mode to another. If the picture is not displayed after switching, turn the monitor off then back on again or switch back to the computer in power save mode and bring in out of power save mode. Appendixes 141 Troubleshooting