Toro 20330 Service Manual - Page 130
If the handle has been binding, clean the top slides
UPC - 021038203300
View all Toro 20330 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
HANDLES AND CONTROL CABLES 2. Squeeze the ends of the upper bail to disengage them from the handle. On some models the right side of the bail may be connected to the pin by a push nut. The push nut can be removed or the bail removed with the pin attached (Fig. 247). 4. Slide the pin out of the left hand handle and pull the upper handle up and out. 5. The plastic sleeves will slide off the upper handle. 6. The springs can be removed from the top slides if necessary. Assembly If the handle has been binding, clean the top slides and the sleeves before assembling. Dirt and grit in the sliding part of the handle can cause a bind. Assemble in reverse order. When you install the upper handle, line up the holes and install the pivot pins (Fig. 249). Fig 247 DSC-4871a 3. Remove the shoulder bolt and the traction lever (Fig. 248). Fig 248 DSC-4880a Fig 249 DSC-4885a 7-10 WPM Drive Systems Manual