Toro 20330 Service Manual - Page 83
Grease with No. 2 lithium-based grease. Use
UPC - 021038203300
View all Toro 20330 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
13. Place the wheel pinion onto the output shaft. It is symmetrical and can be put on either way. 14. Install the internally tabbed thrust washer onto the output shaft making sure that the tab enters the keyway. 15. Slip the spring onto the end of the output shaft and secure with the special retaining clip. Again, make sure that the center tab fits properly into the keyway to prevent rotation of the clip (Fig. 140). WHEEL PINION CLUTCH Fig 140 3428-0040 16. Slip the wheel, the original number of spacers, and the wheel cover onto the shoulder bolt and secure to the pivot arm using the nylon locknut. 17. Grease with No. 2 lithium-based grease. Use a hand grease gun to avoid excess pressure that may prevent the friction parts from working. As a rule, use two pumps to ensure that you do not over-grease. Be sure to grease after every 25 hours of use for maximum service life. WPM Drive Systems Manual 5-7