Toshiba A60-S1691ST User Manual - Page 130

POWER AND POWER-UP MODES User's Manual ❑ The battery has not been used for a long time. ❑ The battery has completely discharged and been left in the computer for a long time. ❑ A cool battery is installed in a warm computer. In such case, follow the steps below. 1. Fully discharge the battery by leaving it in the computer with the power on until the power automatically shuts off. 2. Plug in the AC adaptor. 3. Charge the battery until the Battery indicator glows green. Repeat the steps two or three times until the battery recovers normal capacity. NOTES : Leaving the AC adaptor connected will shorten battery life. At least once a month, run the computer on battery power until the battery is fully discharged, then recharged the battery. Monitoring battery capacity Remaining battery power can be monitored in TOSHIBA Power Saver. NOTES: 1. Wait at least 16 seconds after turning on the computer before trying to monitor the remaining operating time. The computer needs this time to check the battery's remaining capacity and to calculate the remaining operating time, based on the current power consumption rate and remaining battery capacity. The actual remaining operating time may differ slightly from the calculated time. 2. With repeated discharges and recharges, the battery's capacity will gradually decrease. Therefore, an often used, older battery will not operate for as long as a new battery even when both are fully charged. In this case, TOSHIBA Power Saver will indicate a 100% charge for both the old and new battery, but the displayed estimated time remaining will be shorter for the older battery. 6-10