Xerox 3300MFP User Guide - Page 86
Over Heat Error - scanner locked
UPC - 095205744415
View all Xerox 3300MFP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
Message Open Heat Error Cycle Power Operation Not Assigned Over Heat Error Cycle Power Paper Jam 0 Open/Close Door Paper Jam 1 Open/Close Door Paper Jam 2 Check Inside Power Failure Retry Redial? Scanner locked Self Diagnostic LSU Self Diagnostic Temperature Send Error (AUTH) Meaning Suggested solutions There is a problem in the fuser unit. Unplug the power cord and plug it back in. If the problem persists, please call for service. You are in the Add Page/Cancel Job operation, but there are no jobs stored. Check the display to see if there are any scheduled jobs. There is a problem in the fuser unit. Unplug the power cord and plug it back in. If the problem persists, please call for service. Paper has jammed in the feeding area of the tray. Clear the jam. See page 14.2 and page 14.3. Paper has jammed in the fuser area. Clear the jam. See page 14.3. Paper has jammed in the paper exit area. Clear the jam. See page 14.4. Power has turned off then on and the machine's memory has not been back up. The job which you were trying to do before the power failure must be completely re-done. The machine is waiting for a specified time interval to redial a previously busy station. You can press Enter to immediately redial, or Stop/Clear to cancel the redial operation. The scanner module Unlock the scanner and is locked press Stop/Clear. The LSU (Laser Scanning Unit) in your printer is checking some problems detected. Please wait a few minutes. The engine in your machine is checking some problems detected. Please wait a few minutes. There is a problem in SMTP authentication. Configure the authentication setting. Message Send Error (DNS) Send Error (POP3) Send Error (SMTP) Send Error (Wrong Config) [Stop Pressed] Tray 1 Paper Empty Tray 2 Paper Empty Meaning Suggested solutions There is a problem in DNS. Configure the DNS setting. There is a problem in POP3. Configure the POP3 setting. There is a problem in SMTP. Change to the available server. There is a problem on the network interface card. Configure your network interface card correctly. Stop/Clear has been pressed during a fax transmission. Try again. There is no paper in Load paper in tray 1. See the tray 1. page 5.5. There is no paper in the optional tray 2. Load paper in the optional tray 2. See page 5.5. 14.9