Xerox 8560MFP Advanced Features Guide - Page 57
Macintosh Troubleshooting (Mac OS 9.x, Mac OS X, Version 10.2 and Higher), Mac OS 9.x Troubleshooting
UPC - 095205428841
View all Xerox 8560MFP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Macintosh Macintosh Troubleshooting (Mac OS 9.x, Mac OS X, Version 10.2 and Higher) The following procedure eliminates cabling, communication, and connection problems. Once you complete these steps, print a test page from your software application. Note: If the job prints, no further system troubleshooting is necessary. If there are print-quality problems, see the User Guide at www.xerox.com/office/8510_8560support. Mac OS 9.x Troubleshooting Perform these steps only for Mac OS 9: 1. Open the Chooser, and then click the LaserWriter driver. 2. Do one of the following: ■ If the system's name appears, your device is communicating through the network. You do not need to perform any additional steps. ■ If the system's name does not appear, proceed to Step 3. 3. Verify that the system is plugged in, turned On, and connected to an active network. 4. Verify the cable connection from the network to the system. 5. Follow these steps: a. From the system's control panel, verify that EtherTalk is enabled. If it is not, enable it in the control panel, and then reset the system. b. Print the Configuration page and verify that EtherTalk is enabled. c. From the Configuration page, verify the Zone. If you have multiple zones on your network, verify that your system appears in the desired zone. 6. If you are still unable to print, access PhaserSMART Technical Support through CentreWare IS: a. Launch your web browser. b. Enter the system's IP address in the browser's Address field (http://xxx.xxx.xxx.xxx). c. Select Support. d. Click the PhaserSMART Diagnostic Tool link to access PhaserSMART. See also: www.xerox.com/office/8510_8560support Phaser® 8510/8560MFP Multifunction Product 3-20