2010 Dodge Ram 1500 Regular Cab Owner Manual - Page 151
2010 Dodge Ram 1500 Regular Cab Manual
Page 151 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 149 successfully accepted the frequency signal. The EVIC 1. Turn the ignition switch to the ON/RUN position. display will change from "CHANNEL # TRAINING" to 2. Press and hold the desired HomeLink button for "CHANNEL # TRAINED." 20 seconds until the EVIC display states "CHANNEL # If you unplugged the device for training, plug it back in TRAINING." Do not release the button. at this time. 3. Without releasing the button, proceed with ProgramThen proceed with Step 4 under "Programming ming HomeLink Step 2 and follow all remaining steps. HomeLink" earlier in this section. Security Using HomeLinkா It is advised to erase all channels before you sell or turn To operate, press and release the programmed in your vehicle. HomeLink button. Activation will now occur for the To do this, press and hold the two outside buttons for trained device (i.e., garage door opener, gate operator, 20 seconds until the EVIC message states "CHANNELS security system, entry door lock, home/office lighting, CLEARED." Note that all channels will be erased. Indietc.,). The handheld transmitter of the device may also be vidual channels cannot be erased. used at any time. The HomeLink Universal Transceiver is disabled when Reprogramming A Single HomeLinkா Button the Vehicle Security Alarm is active. To reprogram a channel that has been previously trained, follow these steps: 3