2010 Dodge Ram 1500 Regular Cab Owner Manual - Page 210
2010 Dodge Ram 1500 Regular Cab Manual
Page 210 highlights
208 UNDERSTANDING YOUR INSTRUMENT PANEL depending on driving habits and vehicle usage. Press the Odometer / Trip Odometer / ECO (Fuel Saver Indicator) button to change the display from odometer to either of the two trip odometer settings or the "ECO" display. If the vehicle diagnostic system determines that the fuel filler cap is loose, improperly installed, or damaged, a loose gascap indicator Loose will display in the odometer display area. Gascap Tighten the fuel filler cap properly and press Indicator the TRIP button to turn off the message. If the problem continues, the message will appear the next time the vehicle is started. noFUSE If the vehicle diagnostic system determines that the Ignition Off Draw (IOD) fuse is improperly installed, or damaged, a "noFUSE" message will display in the odometer display area. For further information on fuses and fuse locations refer to "Fuses" in "Maintaining Your Vehicle". CHAngE OIL Your vehicle is equipped with an engine oil change indicator system. The CHAngE OIL message will flash in the instrument cluster odometer for approximately 12 seconds after a single chime has sounded to indicate A loose, improperly installed, or damaged fuel filler cap the next scheduled oil change interval. The engine oil may also turn on the Malfunction Indicator Light (MIL). change indicator system is duty cycle-based, which means the engine oil change interval may fluctuate Lo tirE dependent upon your personal driving style. When the appropriate condition exists, the odometer display will toggle between Lo and tirE for three cycles. Unless reset, this message will continue to display each time you turn the ignition switch to the ON position. To