2010 Dodge Ram 1500 Regular Cab Owner Manual - Page 53
2010 Dodge Ram 1500 Regular Cab Manual
Page 53 highlights
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 51 NOTE: These devices are not a substitute for proper seat driver front belt is fastened. The driver should instruct all belt placement by the occupant. The seat belt still must be other occupants to fasten their seatbelts. If the driver seatbelt is unbuckled while traveling at speeds greater worn snugly and positioned properly. than 5 mph (8 km/h), BeltAlert will chime as a single The pretensioners are triggered by the Occupant Renotification and illuminate the Seat Belt Reminder Light, straint Controller (ORC). Like the airbags, the pretensionthen will proceed to the 96 second reminder sequence. ers are single use items. A deployed pretensioner or a BeltAlert can be enabled or disabled by your authorized deployed airbag must be replaced immediately. dealer or by performing the following procedure: Enhanced Seat Belt Use Reminder System NOTE: The following steps must occur within the first (BeltAlertா) BeltAlert is a feature intended to remind the driver to 60 seconds of the ignition switch being turned to the fasten their seatbelt. This feature is active whenever the ON/RUN or START position. Chrysler Group LLC does ignition is on. If the driver is unbelted, the Seat Belt not recommend deactivating the BeltAlert. Reminder Light will turn on and remain on until the 1. With all doors closed and the ignition switch in any driver seatbelt is fastened. BeltAlert triggers within position except ON/RUN or START, buckle the driver's 60 seconds of vehicle speed over 5 mph (8 km/h). The seat belt. reminder sequence lasts for 96 seconds or until the driver seatbelt is fastened. After the sequence completes, the 2. Turn the ignition switch to the ON/RUN position and Seat Belt Reminder Light remains illuminated until the wait for the Seat Belt Reminder Light to turn off. 2