2010 Dodge Ram 1500 Regular Cab Owner Manual - Page 211

UNDERSTANDING YOUR INSTRUMENT PANEL 209 turn off the message temporarily, press and release the Trip Odometer button on the instrument cluster. To reset the oil change indicator system (after performing the scheduled maintenance), refer to the following procedure: single chime will sound after reaching a set threshold. Further overheating will cause the temperature gauge to pass H, the indicator will continuously flash and a continuous chime will occur until the engine is allowed to cool. 1. Turn the ignition switch to the ON position (Do not If the light turns on while driving, safely pull over and start the engine). stop the vehicle. If the A/C system is on, turn it off. Also, shift the transmission into NEUTRAL and idle the ve2. Fully depress the accelerator pedal slowly three hicle. If the temperature reading does not return to times within 10 seconds. normal, turn the engine off immediately and call for 3. Turn the ignition switch to the OFF/LOCK position. service. Refer to "If Your Engine Overheats" in "What To Do In Emergencies" for further information. NOTE: If the indicator message illuminates when you start the vehicle, the oil change indicator system did not For vehicles equipped with a premium cluster this indicator will display in the Electronic Vehicle Information reset. If necessary repeat this procedure. Center (EVIC). Refer to "Electronic Vehicle Information 17. Engine Temperature Warning Light Center (EVIC) - If Equipped" for further information. This light warns of an overheated engine condition. As temperatures rise and the gauge approaches H, this indicator will illuminate and a 4