2010 Dodge Ram 1500 Regular Cab Owner Manual - Page 329
2010 Dodge Ram 1500 Regular Cab Manual
Page 329 highlights
STARTING AND OPERATING 327 When the shift is complete, the position indicator light selected position indicator light will flash and the origifor the selected position will stop flashing and remain nal position indicator light will remain ON. At this time, reduce speed and stop spinning the wheels to complete ON. the shift. 2WD⇔ 4WD LOCK Rotate the 4WD control switch to the desired position. 2WD or 4WD LOCK⇔ 4WD LOW Shifts between 2WD and 4WD LOCK can be done with NOTE: When shifting into or out of 4WD LOW some the vehicle stopped or in motion. With the vehicle in gear noise may be heard. This noise is normal and is not motion, the transfer case will engage/disengage faster if detrimental to the vehicle or occupants. you momentarily release the accelerator pedal after turning the control switch. If the vehicle is stopped, the Shifting can be performed with the vehicle rolling 2 to ignition switch must be in the ON position with the 3 mph (3 to 5 km/h) or completely stopped. You can use engine either running or off. This shift cannot be com- either of the following procedures: pleted if the ignition switch is in the ACC position. Preferred Procedure NOTE: The four-wheel drive system will not allow 1. With the engine running, slow the vehicle to 2 to shifts between 2WD/4WD LOCK if the front and/or rear 3 mph (3 to 5 km/h). wheels are spinning (no traction). In this situation, the 2. Shift the transmission into NEUTRAL. 5