2010 Dodge Ram 1500 Regular Cab Owner Manual - Page 303
2010 Dodge Ram 1500 Regular Cab Manual
Page 303 highlights
STARTING AND OPERATING 301 If the engine has been flooded, it may start to run, but not have enough power to continue running when the key fob is released. If this occurs, continue cranking with the accelerator pedal pushed all the way to the floor. Release the accelerator pedal and the key fob once the engine is running smoothly. 1500 Models The engine block heater cord is routed under the hood on the passenger side of the vehicle near the right head lamp assembly. It is located between the front grill and the radiator, but underneath the black upper seal. 2500/3500 Models If the engine shows no sign of starting after two 15- The engine block heater cord is routed through the grille second periods of cranking with the accelerator pedal by the right front tow hook. held to the floor, the "Normal Starting" procedure should It includes a removable cap that is secured by a tethered be repeated. strap. It also has a c-clip that is used for storage when not in use for the winter months. During winter months, After Starting The idle speed is automatically controlled and will de- remove the heater cord wiring assembly from itself on the c-clip. crease as the engine warms up. ENGINE BLOCK HEATER - IF EQUIPPED The engine block heater warms the engine and permits quicker starts in cold weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a grounded, three-wire extension cord. 5