2010 Dodge Ram 1500 Regular Cab Owner Manual - Page 209
2010 Dodge Ram 1500 Regular Cab Manual
Page 209 highlights
UNDERSTANDING YOUR INSTRUMENT PANEL 207 The two trip odometers show individual trip mileage. To running. To display the engine hours on the base cluster, switch from odometer to trip odometers, press and perform the following: Place the ignition in RUN, but do release the TRIP ODOMETER button. not start the engine. With the odometer value displayed, hold the TRIP button down for a period of six seconds. To reset a trip odometer, display the desired trip odomThe odometer will change to trip value first, then it will eter to be reset then push and hold the button for display the engine hour value. The engine hours will be approximately two seconds until the display resets. displayed for a period of 30 seconds until the ignition is Vehicle Odometer Messages turned OFF or the engine is started. When the appropriate conditions exist, the following If equipped, some of the above warnings will be dismessages will display in the odometer: played in the Electronic Vehicle Information Center (EVIC) in the instrument cluster. Refer to "Electronic ECO ...Fuel Saver Indicator Off Vehicle Information Center (EVIC) - If Equipped" for ECO-ON ...Fuel Saver Indicator On further information. Lo tirE ...Low Tire Pressure noFUSE ...Fuse Fault ECO / ECO-ON (Fuel Saver Indicator) - If Equipped CHAngE OIL ...Oil Change Required The ECO-ON indicator will illuminate when you are LoWASH ...Low Washer Fluid driving in a fuel efficient manner and can be used to modify driving habits in order to increase fuel economy. NOTE: There is also an engine hour function. This The ECO display will toggle between ECO and ECO-ON indicates the total number of hours the engine has been 4