2010 Dodge Ram 1500 Regular Cab Owner Manual - Page 330
2010 Dodge Ram 1500 Regular Cab Manual
Page 330 highlights
328 STARTING AND OPERATING 3. While still rolling, rotate the transfer case control NOTE: • If Steps 1 or 2 of either the Preferred or Alternate switch to the desired position. Procedure are not satisfied prior to attempting the 4. After the desired position indicator light is ON (not shift, then the desired position indicator light will flash flashing), shift the transmission back into gear. continuously while the original position indicator light is ON, until all requirements have been met. Alternate Procedure • The ignition switch must be in the ON position for a shift to take place and for the position indicator lights 2. With the ignition switch in the ON position and the to be operable. If the ignition switch is not in the ON engine either OFF or running, shift the transmission into position, the shift will not take place and no position NEUTRAL. indicator lights will be on or flashing. 3. Rotate the transfer case control switch to the desired Electronically Shifted Transfer Case position. (Five-Position Switch) - If Equipped 4. After the desired position indicator light is ON (not This is an electronic shift transfer case and is operated by the 4WD Control Switch (Transfer Case Switch), which is flashing), shift the transmission back into gear. located on the instrument panel. 1. Bring the vehicle to a complete stop.