2010 Dodge Ram 1500 Regular Cab Owner Manual - Page 336
2010 Dodge Ram 1500 Regular Cab Manual
Page 336 highlights
334 STARTING AND OPERATING the vehicle in motion, the transfer case will engage/ disengage faster if you momentarily release the accelerator pedal after turning the control switch. If the vehicle is stopped, the ignition switch must be in the ON position with the engine either running or OFF. This shift cannot be completed if the ignition switch is in the ACC position. 2WD or 4WD AUTO or 4WD LOCK ⇔ 4WD LOW 2. Shift the transmission into NEUTRAL. 3. While still rolling, rotate the transfer case control switch to the desired position. 4. After the desired position indicator light is ON (not flashing), shift the transmission back into gear. Alternate Procedure NOTE: When shifting into or out of 4WD LOW some 1. Bring the vehicle to complete stop. gear noise may be heard. This noise is normal and is not 2. With the ignition switch in the ON position and the detrimental to the vehicle or occupants. engine either OFF or running, shift the transmission into Shifting can be performed with the vehicle rolling 2 to NEUTRAL. 3 mph (3 to 5 km/h) or completely stopped. Use either of 3. Rotate the transfer case control switch to the desired the following procedures: position. Preferred Procedure 4. After the desired position indicator light is ON (not 1. With the engine running, slow the vehicle to 2 to flashing), shift the transmission back into gear. 3 mph (3 to 5 km/h).