2010 Dodge Ram 1500 Regular Cab Owner Manual - Page 474
2010 Dodge Ram 1500 Regular Cab Manual
Page 474 highlights
472 STARTING AND OPERATING 7. After the NEUTRAL indicator light turns off, release NOTE: • Steps 1 through 5 are requirements that must be met the NEUTRAL button. prior to pressing the transfer case NEUTRAL button 8. After the NEUTRAL button has been released, the and must continue to be met until one second elapses transfer case will shift to the position identified by the and the shift has been completed. If any of these selector switch. requirements are not met prior to pressing the NEUTRAL button, or are no longer met during the one 9. Shift the transmission into PARK. second time, then all of the mode position indicator 10. Release the brake pedal. lights will flash continuously until all requirements are met or until the NEUTRAL button is released. 11. Disconnect vehicle from the tow vehicle. 12. Start the engine. 13. Press and hold the brake pedal. 14. Release the parking brake. • The ignition switch must be in the ON position for a transfer case shift to take place and for the position indicator lights to be operable. If the ignition switch is not in the ON position, the shift will not take place and no position indicator lights will be on or flashing. 15. Shift the transmission into DRIVE, release the brake • The flashing NEUTRAL position indicator light indipedal, and check that the vehicle operates normally. cates that shift requirements have not been met.