2010 Dodge Ram 1500 Regular Cab Owner Manual - Page 32

30 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE Settings (System Setup)" in "Understanding Your InIf you press the power door LOCK switch while the Key strument Panel" for further information. Fob is in the ignition, and any front door is open, the power locks will not operate. This prevents you from • For vehicles not equipped with the EVIC, perform the accidentally locking your Key Fob in the vehicle. Removfollowing procedure: ing the Key Fob or closing the door will allow the locks to operate. A chime will sound if the Key Fob is in the 1. Enter your vehicle and close all doors. ignition switch and a door is open, as a reminder to 2. Fasten your seat belt. (Fastening the seat belt will remove the Key Fob. cancel any chiming that may confuse you during this Auto Lock Doors - If Equipped programming procedure.) If this feature is enabled, your door locks will lock 3. Place the Key Fob into the ignition. automatically when the vehicle's speed exceeds 15 mph (24 km/h). 4. Within 15 seconds cycle the Key Fob from the OFF position to the ON position a minimum of four times, Auto Lock Doors Programming ending in the OFF position. (Do not start the engine). The Auto Lock Doors feature can be enabled or disabled as follows: 5. Within 30 seconds, press the driver's door LOCK switch. • For vehicles equipped with the EVIC, refer to "Electronic Vehicle Information Center (EVIC)/Personal 6. A single chime will be heard to indicate the feature has been disabled.