2013 Ford Escape Warranty Supplement Printing 1 - Page 178

Load Carrying The maximum recommended load, evenly distributed on the crossbars, is: • 100 pounds (45 kilograms) for vehicles without a moonroof • 45 pounds (20 kilograms) for vehicles with a moonroof. Note: Loads should never be placed directly on the roof panel. The roof panel is not designed to directly carry a load. E142447 Insert the ends of the cargo shade into the mounting features located behind the rear seat on the rear trim panels to install the shade. To operate the shade: 1. Pull the rear edge of the cargo shade rearward. 2. Secure both ends of the support rod into the retention slots located on the rear quarter trim panels. For proper function of the roof rack system, loads must be placed directly on crossbars affixed to the roof rack side rails. Your vehicle may be equipped with factory-installed crossbars. Ford Genuine Accessory crossbars, designed specifically for your vehicle, are also recommended for use with your roof rack system. Make sure that the load is securely fastened. Check the tightness of the load before driving and at each fuel stop. Adjusting the Crossbar (If Equipped) Note: Wind noise can be minimized by either removing or repositioning the crossbar when not is use. Position the front crossbar in the rearward position to minimize wind noise. The front crossbar can be adjusted or removed using the steps below. The rear crossbar fasteners can be removed by unscrewing the assembly. ROOF RACKS AND LOAD CARRIERS WARNING When loading the roof rail crossbars, it is recommended to evenly distribute the load, as well as maintain a low center of gravity. Loaded vehicles, with higher centers of gravity, may handle differently than unloaded vehicles. Extra precautions, such as slower speeds and increased stopping distance, should be taken when driving a heavily loaded vehicle. E142448 178