2013 Ford Escape Warranty Supplement Printing 1 - Page 179

Load Carrying 1. Remove the crossbar thumbwheels at both sides of the front crossbar by turning them counterclockwise. Note: A small screwdriver or similar tool can be used to loosen the thumbwheel. Apply to the fastener head on the top of the thumbwheel or insert the shaft between the two paddles of the thumbwheel and rotate it loose. 2. Remove the crossbar by sliding the ends off of the shoulder bolts in the side rails. 3. Move the crossbar to the new side rail position and slide the crossbar onto the shoulder bolt at that position. 4. Replace and tighten the thumbwheels at both sides of the crossbar by turning them clockwise until tight. A small screwdriver or similar tool can be used to tighten if necessary. Make sure to check that the thumbwheels are tight each time load is added or removed from the roof rack, and periodically while traveling. Make sure that the load is secure before traveling. LOAD LIMIT Vehicle loading - with and without a trailer This section will guide you in the proper loading of your vehicle, trailer or both, to keep your loaded vehicle weight within its design rating capability, with or without a trailer. Properly loading your vehicle will provide maximum return of vehicle design performance. Before loading your vehicle, familiarize yourself with the following terms for determining your vehicle's weight ratings, with or without a trailer, from the vehicle's Tire Label or Safety Compliance Certification Label: Base Curb Weight - is the weight of the vehicle including a full tank of fuel and all standard equipment. It does not include passengers, cargo, or optional equipment. Vehicle Curb Weight - is the weight of your new vehicle when you picked it up from your authorized dealer plus any aftermarket equipment. E142513 179