Alpine 1004 Owners Manual - Page 10

Basic Operation MUTE/SETUP TILT 7 8 Adjusting Volume/Balance (Between Left and Right)/Fader (Between Front and Rear) 1 Press MODE (Rotary encoder) repeatedly to choose the desired mode. Each press changes the modes as follows: → NAV∗1 → SUB-W∗2 → BAL → FAD → VOL MODE (Rotary encoder) Adjusting the Monitor Viewing Angle Adjust the monitor's angle for better visibility. 1 Press TILT 7 8 to adjust the monitor's angle so the screen will be in the best viewing position. Each press of the buttons produces a beep and changes the screen angle between about 40 and 105 degrees. When you press and hold 7 or 8 (TILT) for at least 2 seconds, the monitor's angle keeps moving until you release the button. NOTES • If the monitor touches an obstacle while the angle is being adjusted the unit will stop the screen immediately. Should this happen, remove the obstacle and press TILT 7 8 again. • The screen color will vary when viewed at certain angles. Adjust the screen angle for the best viewing position. • If the voltage of the vehicle's battery power is low, the screen may blink when the screen angle is changed. This is normal and not a malfunction. CAUTION Keep hands (or any other object) away from the display while it is opening or closing to avoid damage or injury. The back of the movable display will get very warm under normal operating conditions. This is not a malfunction. Do not touch. Volume: 0~35 Balance: L15~R15 Fader: R15~F15 NAV.Level: 0~15 Subwoofer: 0~15 NOTE • If the Rotary encoder is not turned in 5 seconds after selecting the BALANCE, FADER, NAV. Level or SUBWOOFER mode, the unit automatically returns to the VOLUME mode. ∗1 When the SUBWOOFER mode is OFF (page 34), its level cannot be adjusted. ∗2 When the NAV.MIX mode is OFF (page 20), its level cannot be adjusted. 2 Turn MODE (Rotary encoder) until the desired sound is obtained in each mode. Audio Mute Function Activating this function will instantly lower the volume level by 20 dB. 1 Press MUTE/SETUP to activate the MUTE mode. The audio level will decrease by about 20 dB. Pressing MUTE/SETUP again will bring the audio back to its previous level. 8-EN