Alpine 1004 Owners Manual - Page 23

MobileHub™ Link Operation (Optional) BAND/TEL. :/J About MobileHub™ Link Connect a separately sold Junction Box and a portable telephone (available from Nokia) to control the incoming and outgoing calls of the portable telephone. Functions that can be operated from CVA-1004 Incoming Calls Outgoing Calls Short Messages Automatically receive Manually receive Missed call announcement (information icon) Call out (Speed Dial) Call out (phone book) Call out (dialled) Call out (received) Display receiving history Display short message Mail arrival announcement (information icon) Call out (missed call) CAUTION • Even with hands-free operation, a driver can be distracted during telephone operation or receiving a call. For the sake of safety, drivers are requested to refrain from operating the telephone while driving. • For the sake of safety, operations other than incoming calls and Speed-Dial outgoing calls cannot be used. NOTES • If a portable telephone is connected, its address book, incoming and outgoing history and short message history are downloaded to the Junction Box. • Please refer to the instruction manual of the Junction BOX. Telephone Mode On and Off 1 Press BAND/TEL. for at least 2 seconds. See relevant pages for each item. NOTES • When a portable telephone is not connected, "NO PHONE" is displayed for at least 2 seconds, then the mode returns to the original source mode. • When the portable telephone is taken off the Junction BOX during an incoming or outgoing call, or during a hands-free call, the call will be treated as an ordinary one by the portable telephone. • When there is an incoming call while the power of CVA-1004 is OFF, the power of CVA-1004 will turn ON automatically for an ordinary call by the portable telephone, but not for a hands-free call. • Even if the power of the portable telephone is OFF, when CVA-1004 is set to the telephone mode, the power of the portable telephone will be turned ON. • Even if the ACC power of the vehicle is turned OFF (even if the engine is stopped) during a hands-free call, the call is not disconnected, and an ordinary call by the portable telephone is possible. • If there is an incoming call during operation (except an outgoing call or talking), operation mode will end and switch to the incoming or talking mode. • An outgoing call from a portable telephone is also possible. However, you cannot perform different operations at the same time from a portable telephone and CVA-1004 as malfunction can result. • With a Junction BOX connected, outgoing and incoming history will also be recorded in the portable telephone. • While telephoning, the setting of CVA-1004 automatically turns to DEFEAT ON. • When the call has finished, the unit returns to your previous settings. • The telephone volume can be adjusted from the CVA1004. The volume you set during the call is memorized, and is automatically applied again on the next call. • If you press TITLE in the display for selecting the calling method, the Network Operator display will be shown. Press TITLE again to return to the previous display. • During a call, you can send dial tone signals 1 to 6 using preset buttons 1 through 6, and dial tone signals 7 to 9, 0, and by pressing FUNC, and then preset buttons 1 through 6. Incoming Calls 1 Press -/J to receive an incoming call. 2 Press and hold BAND/TEL. for at least 2 seconds to finish a call. The telephone mode will end and return to the original source mode. NOTES • When the Automatic Calling mode is on, you can talk after 3 seconds of receiving the incoming call. • To switch between automatic calling and manual calling, refer to "Setting the Call Receiving Method" (page 23). • Press and hold BAND/TEL. for at least 2 seconds during an incoming call to disconnect it. • You can call back by pressing :/J within 5 seconds after finishing a call. 21-EN