Alpine 1004 Owners Manual - Page 48

Installation and Connections Installation 3 Installing the Monitor • Location Before final installation, make sure the display will not hamper gear shifting when it is opened and closed in the chosen location. Lock Pin NOTE Install at an angle within 30 degrees from horizontal. 1 Mounting Sleeve (Included) Dashboard Mounting Bracket (Included) CVA-1004 Screws(M4x5) (Included) Slide mounting sleeve from main unit (see Removal Procedure below). Slide the mounting sleeve into the dashboard. Install the supplied bracket to the monitor. 2 Screw Hex Nut (M5) Metal Mounting Strap Bolt Stud CVA-1004 Slide the CVA-1004 into the dashboard. When the unit is in place, make sure the locking pins are fully seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the Supplied Front Frame. Removal 1 Use a small screwdriver (or similar tool) to push the locking pins to the "up" position (see above drawing). As each pin is unlocked, gently pull out on the unit to make sure it does not re-lock before unlocking the second pin. 2 Pull the unit out, keeping it unlocked as you do so. Installation using the vehicle's factory brackets. CVA-1004 Ground Lead Screws (M4x5) Mounting Bracket Ground Lead Chassis Front Frame (Included) Reinforce the monitor with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw ( ) already attached to the vehicle's chassis. NOTE For the screw marked , use an appropriate screw for the chosen mounting location. 46-EN