Alpine 1004 Owners Manual - Page 22
Navigation System Operation Optional - cva navigation
View all Alpine 1004 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Navigation System Operation (Optional) SOURCE/ PWR MUTE/SETUP 3 Press g or f to select ON or OFF. ON: The volume level of the navigation system's voice guidance can be adjusted in 15 steps. OFF:The navigation system's voice guidance is not output. (For details about adjusting volume level, refer to "Adjusting Volume/Balance/Fader" on page 8.) gf Preset 5 Turning on the Navigation Mode If an optional Alpine Navigation System is connected , The display shows the navigation screen. 1 Press SOURCE/PWR to select the Navigation mode. NOTE If the Navigation mode does not appear in the display by pressing SOURCE/PWR, set the external setting of NAV.IN to ON (refer to "Setting the External Input" on page 37.) Interrupt Feature (NAV. MIX) For any other settings, press preset 5 or another preset button. 4 After setting is completed, press MUTE/SETUP to return to normal mode. NOTES • The volume level of the audio will be automatically reduced when the voice guidance of the Navigation system starts. • When the voice guidance of the Navigation system starts to interrupt the audio, the display is automatically changed to the navigation screen. Interrupt Feature(NAV.MIX OUT) With an ALPINE navigation system connected to the CVA-1004, the navigation system's voice guidance is mixed in and output from the Rear/ Subwoofer Output RCA connectors. This function is not available when an external audio processor is connected. After carrying out steps 1 to 3 of "To display the SETUP screen" (page 29), perform the operation shown below. With an Alpine navigation system connected to the CVA-1004, the voice guidance of the navigation system will be mixed with the radio or CD audio, etc. You can also adjust the volume level of the voice guidance. If you use this unit connected to an external audio processor, you cannot use this function (except PXA-H700). After carrying out steps 1 to 3 of "To display the SETUP screen" (page 29), perform the operation shown below. 1 When the monitor is open, press and hold MUTE/SETUP for at least 2 seconds. The SETUP screen appears. 2 Press preset 5 to activate the SYSTEM setting mode. Press preset 5 again to select NAV. MIX. 1 When the monitor is open, press and hold MUTE/SETUP for at least 2 seconds. The SETUP screen appears. 2 Press preset 5 to activate the SYSTEM setting mode. Press preset 5 again to select NAV.MIX OUT. 3 Press g or f to select ON or OFF. Select ON to allow the navigation system's voice guidance to interrupt the external amplifier. For any other settings, press preset 5 or another preset button. 4 After setting is completed, press MUTE/SETUP to return to normal mode. 20-EN