Brother International BES-116 Instruction Manual - English - Page 151
Winding lower thread, After winding is finished
View all Brother International BES-116 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 151 highlights
Winding lower thread t i e Connection and Installation of Optional Equipment u y r o q w 1. Turn on the power switch. 2. Fit bobbin q to the bobbin winder shaft w. 3. Pass a thread through thread guide e. 4. Wind the thread around bobbin q several times in the direction of the arrow. 5. Press bobbin hold r. Note) • If the thread cannot be wound evenly, loosen screw t and move thread guide e from side to side for adjustment. • To wind more thread around the bobbin, loosen screw y and shift bobbin hold r. 6. After winding is finished, remove the bobbin from the bobbin winder shaft and trim the thread using tread trimmer u. Note) • If the thread passed though thread guide e comes off, loosen knob i. If the thread is wound loosely, tighten knob i. • If circuit protector o is activated, the bobbin winder motor does not rotate. Wait for a while until the motor cools and press the circuit protector. (If the motor is still hot, the pressed circuit protector will come out.) BES-116AC 149