Brother International MFC-6650MC Users Manual - English - Page 97

83 R E M O T E F A X O P T I O N S Remote Commands Follow the commands below to access features remotely. When you call the MFC and enter your Remote Access Code (1 5 9 ), the system will signal you with two short beeps to enter a remote control command. Remote Control Commands Operation Details 95 Changing Fax Forwarding/ Paging setting 1 OFF If you hear one long beep, the change is 2 Fax Forwarding 3 Paging 4 FAX FWD No. accepted. If you hear three short beeps, you cannot change it because the conditions have not been met. (Example: registering paging number). You can register your fax forwarding 6 Fax Storage ON number by using 4. FAX FWD NO (see page 7 Fax Storage OFF 95). Once you have registered the number, the MFC will change automatically to FAX FWD:ON mode. Then retrieve a Memory Status List by entering 961 (see page 107) to make sure that the Fax Forwarding number you registered is correct on the List. You can set FAX STORAGE to ON or OFF. 96 Retrieve FAX 1 Memory Status List Enter the number of a remote fax machine to 2 Retrieve all faxes receive the Memory Status List or stored fax message(s). (See page 107). 3 Erase fax from the memory If you hear one long beep, you can erase fax message(s) from the memory. 97 Check the receiving status 1 FAX You can check whether your MFC has received any fax message(s). If yes, you will hear one long beep. If no, you will hear three short beeps. 98 Change Answer Mode 1 TAD 2 FAX/TEL 3 FAX 90 Exit If you hear one long beep, you can change the Answer Mode. If you hear three short beeps, you cannot change it. After a long beep, you can exit remote control.