Compaq Deskpro 2000 Compaq Deskpro 2000 Series of Personal Computers Pentium P - Page 121
Replacement Battery - cmos battery replacement
View all Compaq Deskpro 2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
5.13 Replacement Battery The real-time clock battery that came with the computer is non-replaceable and is permanently installed on the system board. ! WARNING: The system board contains a clock/CMOS lithium battery. The lithium battery may explode if mistreated. The battery is soldered into place and may not be removed. Do not abuse or disassemble. Use only replacement batteries supplied by Compaq Computer Corporation. It is important to make a set of backup diagnostic diskettes before you install a new battery. To install the external real-time battery, complete the following steps:: 1. Remove the system unit cover (Section 5.6). 2. Connect the new battery to the pins on the battery header connector on the system board. The battery connector is labeled "E9 Ext. Batt." on the Pentium system board and labeled "Ext. Batt." on the Pentium II system board. When this battery is connected, the internal battery is automatically disconnected. The battery connector is keyed for proper installation. 3. Remove the backing from the adhesive on the hook-and-loop fastener strip attached to the battery, and attach the battery as shown. Figure 5-19. Installing the Battery, Pentium System Compaq Deskpro 2000 Series of Personal Computers 5-21