Compaq Deskpro 2000 Compaq Deskpro 2000 Series of Personal Computers Pentium P - Page 176
Mass Storage Devices
View all Compaq Deskpro 2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 176 highlights
6.19 Mass Storage Devices This section discusses the removal and replacement procedures for the mass storage devices that are supported on the Deskpro 2000 Series of Personal Computers. Refer to Chapter 1, Section 1.5.2, "Drive Positions." 6.19.1 3.5-Inch Drive Bays To remove a 3.5-inch drive from the 3.5-inch drive bay, complete the following steps: 1. Remove the access panel (Section 6.6.1). 2. Remove the front bezel (Section 6.16.1). 3. Remove the power switch assembly (Section 6.17.1). 4. Disconnect the cables from the back of the drive. Figure 6-34. Disconnecting the Power 1 and Signal 2 Cables from the 3.5-Inch Diskette Drive When installing a second diskette drive, it is necessary to configure the computer using Computer Setup. Refer to Chapter 7, "Jumper and Switch Information," for the location of the ribbon cable connections on the system board. 6-34 Removal and Replacement Procedures - Minitower