Compaq Deskpro 2000 Compaq Deskpro 2000 Series of Personal Computers Pentium P - Page 147
Exposing the Chassis, Access Panel
![]() |
View all Compaq Deskpro 2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 147 highlights
6.6 Exposing the Chassis 6.6.1 Access Panel To remove the access panel, complete the following steps: 1. Prepare the computer for disassembly (Section 6.3). 2. Remove the thumbscrews at the rear of the computer to release the panel. You may need a flat- bladed screwdriver to loosen a stubborn screw. If the computer has a cable lock mechanism installed, refer to Section 6.5 for removal procedures. 3. Grasp the rear of the panel, pull it back about two to three inches (5 to 7 cm), pivot the top of the access panel out about one inch (2.5 cm), and lift the cover from the computer. Figure 6-4. Removing the Access Panel To replace the cover, reverse the above procedure. Compaq Deskpro 2000 Series of Personal Computers 6-5
![](/manual_guide/products/compaq-280100002-compaq-deskpro-2000-series-personal-computers-pentium-processor-mmx-technology-pentium-ii-processor-1a549f2/147.png)
Compaq Deskpro 2000 Series of Personal Computers
6-5
6.6 Exposing the Chassis
6.6.1
Access Panel
To remove the access panel, complete the following steps:
1.
Prepare the computer for disassembly (Section 6.3).
2.
Remove the thumbscrews at the rear of the computer to release the panel. You may need a flat-
bladed screwdriver to loosen a stubborn screw.
If the computer has a cable lock mechanism installed, refer to Section 6.5 for removal procedures.
3.
Grasp the rear of the panel, pull it back about two to three inches (5 to 7 cm), pivot the top of the
access panel out about one inch (2.5 cm), and lift the cover from the computer.
Figure 6-4.
Removing the Access Panel
To replace the cover, reverse the above procedure.