Compaq Deskpro 2000 Compaq Deskpro 2000 Series of Personal Computers Pentium P - Page 139
When reinstalling the LED ends, note the markings on the front of the chassis for proper
![]() |
View all Compaq Deskpro 2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
Figure 5-38. Removing the LED Cable, Pentium II System 5. Remove the LED ends 2 of the cable from the front of the chassis by gently pulling on the cable while at the same time pushing the ends of the LED from the front of the chassis. To install the LED cable, reverse the above steps. The connector 1 is keyed to ensure proper installation. When reinstalling the LED ends, note the markings on the front of the chassis for proper LED placement. From the front of the chassis, the LED with the black wire goes on the left, and the LED with the white wire on the right. CAUTION: Ensure that the cable is pushed to the bottom of the chassis to avoid being damaged when reinstalling the drive cage. Compaq Deskpro 2000 Series of Personal Computers 5-39
![](/manual_guide/products/compaq-280100002-compaq-deskpro-2000-series-personal-computers-pentium-processor-mmx-technology-pentium-ii-processor-1a549f2/139.png)