Compaq Deskpro 2000 Compaq Deskpro 2000 Series of Personal Computers Pentium P - Page 154
Speaker,
![]() |
View all Compaq Deskpro 2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 154 highlights
6.11 Speaker To remove the speaker, complete the following steps: 1. Remove the access panel (Section 6.6.1). 2. Remove the riser brace (Section 6.7). 3. Disconnect the speaker cable from the audio board or the system board. 4. Remove the two speaker retaining screws. 5. Lift the speaker up out of the retaining tabs. Figure 6-12. Disconnecting the Speaker Cable from the Audio Board To install the speaker, reverse the above procedure. 6-12 Removal and Replacement Procedures - Minitower
![](/manual_guide/products/compaq-280100002-compaq-deskpro-2000-series-personal-computers-pentium-processor-mmx-technology-pentium-ii-processor-1a549f2/154.png)
6-12
Removal and Replacement Procedures - Minitower
6.11 Speaker
To remove the speaker, complete the following steps:
1. Remove the access panel (Section 6.6.1).
2. Remove the riser brace (Section 6.7).
3.
Disconnect the speaker cable from the audio board or the system board.
4. Remove the two speaker retaining screws.
5. Lift the speaker up out of the retaining tabs.
Figure 6-12.
Disconnecting the Speaker Cable from the Audio Board
To install the speaker, reverse the above procedure.