Compaq Deskpro 2000 Compaq Deskpro 2000 Series of Personal Computers Pentium P - Page 192
Changing the Real-Time Clock RTC Battery, Battery Connector E9 Location, Pentium System Board
![]() |
View all Compaq Deskpro 2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 192 highlights
4. Replace the cover and tighten the thumbscrews on the rear panel. 5. Turn the computer on. 6. Run the Computer Setup utility to reconfigure the system. When jumper on the clear-CMOS header is removed, the password becomes invalid because the password is stored in the configuration memory. You will need to reset the password. 7.2.3 Changing the Real-Time Clock (RTC) Battery When installing the replacement RTC battery, the battery connector should be connected to the pins of the battery connector on the system board. The battery connector is labeled "E9 Ext. Batt." on the Pentium system board and labeled "Ext. Batt." on the Pentium II system board. The battery connector is keyed for proper installation. Figure 7-9. Battery Connector (E9) Location, Pentium System Board Figure 7-10. Battery Connector Location, Pentium II System Board Refer to Chapter 5 or Chapter 6 for complete instructions on installing a replacement RTC battery. Compaq Deskpro 2000 Series of Personal Computers 7-9
![](/manual_guide/products/compaq-280100002-compaq-deskpro-2000-series-personal-computers-pentium-processor-mmx-technology-pentium-ii-processor-1a549f2/192.png)