Compaq Deskpro 2000 Compaq Deskpro 2000 Series of Personal Computers Pentium P - Page 126
Compaq Logo,
View all Compaq Deskpro 2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 126 highlights
5.14.4 Compaq Logo To remove the Compaq logo from the front bezel, complete the following steps: 1. Remove the system unit cover (Section 5.6). 2. Remove the front bezel (Section 5.14.1). 3. From the inside of the front bezel, use a small screwdriver at the hole shown in the figure to push the logo out of its recess. 4. Clean the recessed area with a clean, dry cloth. 5. Remove the protective paper from the back of the replacement logo and press the logo into place. Figure 5-24. Replacing the Compaq Logo If the original logo is missing, complete steps 4 and 5 to install a replacement logo without having to remove any part of the computer. 5-26 Removal and Replacement Procedures - Desktop
5-26
Removal and Replacement Procedures - Desktop
5.14.4 Compaq Logo
To remove the Compaq logo from the front bezel, complete the following steps:
1.
Remove the system unit cover (Section 5.6).
2.
Remove the front bezel (Section 5.14.1).
3.
From the inside of the front bezel, use a small screwdriver at the hole shown in the figure to push
the logo out of its recess.
4.
Clean the recessed area with a clean, dry cloth.
5.
Remove the protective paper from the back of the replacement logo and press the logo into place.
Figure 5-24.
Replacing the Compaq Logo
If the original logo is missing, complete steps 4 and 5 to install a replacement logo without having to
remove any part of the computer.