D-Link DSR-1000AC Emulator - Page 132
net ipv6_tunnel isatap delete, net routing mode con
View all D-Link DSR-1000AC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 132 highlights
S.No Command Name Description Type and Description This is the endpoint address for the tunnel that starts with this router. The 6 end_point_type endpoint can be the LAN Select the local end point interface (assuming the address type. LAN is an IPv4 network), or a specific LAN IPv4 address. The local end point address IP address 7 ipv4_address if not the LAN IPv4 AAA.BBB.CCC.DDD where address. each part is in the range 0-255 11.29 net ipv6_tunnel isatap delete S.No Command Name Description Type and Description 1 Deletes a specified isatap tunnel configuration mode. Unsigned integer 11.30 net routing mode configure S.No Command Name Description Type and Description 1 save Saves NAT configuration settings. 2 exit Saves NAT configuration settings and exit current mode. To revert to the previous 3 cancel Basic Security Level configuration settings. Selects NAT or 4 type Transparent or Bridge Routing mode type. mode. Sets IP Addresses for 5 bridgeModeSetup Bridge and DMZ interfaces in same subnet. 6 bridgeModeSetup Gives bridge Interface ip bridge_interfaceIp Address. IP address AAA.BBB.CCC.DDD where each part is in the range 0-255. 7 bridgeModeSetup Gives DMZ Interface ip dmz_interfaceIp Address. IP address AAA.BBB.CCC.DDD where each part is in the range 0-255. 8 bridgeModeSetup subnetMask Gives subnet for the DMZ and Bridge Interfaces. IP address AAA.BBB.CCC.DDD where each part is in the range 0-255. 132