D-Link DSR-1000AC Emulator - Page 66
Rollover on the WAN Mode
![]() |
View all D-Link DSR-1000AC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
S.No Command Name Description Type and Description 12 general_remote_end _point fqdn The IP address or Internet Name/FQDN of the remote gateway or client PC. String. Enables/disables mode 13 general_enable_mo de_config config which is similar to DHCP and is used to assign IP addresses to Boolean choice. remote VPN clients. Enables/disables this to 14 general_enable_net allow NetBIOS broadcasts bios to travel over the VPN Boolean choice. tunnel. Enables this to allow the 15 general_enable_roll over VPN to rollover when WAN Mode is set to Auto Boolean choice Rollover on the WAN Mode page. 16 general_protocol Setting protocol esp or ah. IPsec VPN Protocol 17 general_enable_dhc p Enables/disables dhcp. Boolean choice 18 general_redundant_ Enables/disables vpn_gateway Redundant vpn gateway. Boolean choice 19 general_backup_poli cy_name Backup policy name. String 20 general_failback_tim Failback time to switch e from back-up to primary. Unsigned integer Selects the IP addresses on the local side that will be part of the tunnel. This can 21 general_local_netwo rk_type be either a single IP address, several IP addresses in a range, an Vpn network type entire subnet, or any IP address that wants to connect. 22 general_local_start_ IP address from where the address range needs to begin. IPV4 or IPv6 address depending upon protocol selected IPV4 or IPV6 23 general_local_end_ address IP address where needs to end. the range IPV4 or IPv6 address depending upon protocol selected IPV4 or IPV6 24 general_local_subne Enter the Subnet Mask of t_mask the network. IP address AAA.BBB.CCC.DDD where each part is in the range 0-255 25 general_local_prefix Prefix length of the ipv6 _length subnet used. IPv6 Prefix length 66
![](/manual_guide/products/dlink-dsr1000ac-emulator-7214be4/66.png)