D-Link DSR-1000AC Emulator - Page 172
net radvd con
![]() |
View all D-Link DSR-1000AC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 172 highlights
S.No Command Name Description Type and Description 2 save Saves Protocol-Binding rules configuration settings. 3 exit Save Protocol Binding rules configuration settings and exit current mode. 4 cancel To revert to the previous configuration settings. 5 Service Available Service Service type. 6 Local_Gateway Local gateway type. WAN interface type. 7 Source_Network Source network type. Firewall rule address type. 8 Destination_Network Destination network type. Firewall rule address type. 9 source_address_sta First IP address of the rt Source Network. IP address AAA.BBB.CCC.DDD where each part is in the range 0-255. 10 source_address_en d Last IP of the Source user. IP address AAA.BBB.CCC.DDD where each part is in the range 0-255. 11 destination_address First IP of the Destination _start user. IP address AAA.BBB.CCC.DDD where each part is in the range 0-255. 12 destination_address Last IP of the Destiation _end user. IP address AAA.BBB.CCC.DDD where each part is in the range 0-255. 11.49 net radvd configure S.No Command Name Description Type and Description 1 save Saves radvd configuration settings. 2 exit Saves radvd configuration settings and exit current mode. 3 cancel To revert to the previous radvd configuration settings. 4 enable Enables the RADVD process here to allow stateless auto configuration Boolean choice of the IPv6 LAN network. 5 mode Selects N to send router advertisements (RA's) to interfaces, else Y. all Radvd type. advertizement mode 6 interval The time in seconds between sending PPPOE idle timeout Type. 172
![](/manual_guide/products/dlink-dsr1000ac-emulator-7214be4/172.png)