D-Link DSR-1000AC Emulator - Page 46
Configuration commands, under branch VPN
![]() |
View all D-Link DSR-1000AC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Chapter 6. Configuration commands under branch VPN 6.1 vpn gre_tunnel add S.No Command Name Description Type and Description 1 save Saves system user configuration settings. 2 exit Saves system user configuration settings and exit current mode. 3 cancel To revert to the previous system user configuration settings. 4 tunnelname Enter the Tunnel Name here. String 5 ipaddress Enter here. the tunnel IP Address IP address AAA.BBB.CCC.DDD where each part is in the range 0-255 6 subnet_mask Enter the tunnel Subnet Mask here. IP address AAA.BBB.CCC.DDD where each part is in the range 0-255 7 interface Enter the Interface on which the tunnel is established on. WAN interface type 8 remote_ip 9 ddp_broadcast 10 route_network 11 route_netmask 12 gateway Enter the Remote IP to which the tunnel is being established here. IP address AAA.BBB.CCC.DDD where each part is in the range 0-255 Select enable/disable DDP packet forwarding on the Boolean choice tunnel here. Enter the destination IP address network of GRE tunnel AAA.BBB.CCC.DDD where here. each part is in the range 0-255 Enter the subnet mask of destination network here. IP address AAA.BBB.CCC.DDD where each part is in the range 0-255 Enter the gateway of the destination network here. IP address AAA.BBB.CCC.DDD where each part is in the range 0-255 46
![](/manual_guide/products/dlink-dsr1000ac-emulator-7214be4/46.png)