Dell PowerConnect W-IAP92 Dell Instant 5.0.3.0-1.1.0.0 User Guide - Page 55
Syslog Server, Adding an W-IAP to the Network,
View all Dell PowerConnect W-IAP92 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Syslog Server Go to Settings > Advanced > Syslog Server to specify a Syslog Server for sending all syslog messages to the external servers. Figure 41 Syslog Server Adding an W-IAP to the Network To add an W-IAP to the Dell Instant network, assign an IP address. For more information, see "Assigning an IP Address to the W-IAP" on page 18. After an W-IAP is connected to the network, if the Auto Join Mode feature is enabled, it is listed in the Access Points tab in the Instant UI. The W-IAP inherits the configuration and image from the virtual controller. If the Auto Join Mode is not enabled, then perform the following steps to add an W-IAP to the network: 1. In the Access Points tab, click the New link. Figure 42 Adding an W-IAP to the Instant Network 2. In the New Access Point box, enter the MAC address for the new W-IAP. Figure 43 Entering the MAC Address for the New W-IAP Dell PowerConnect W-Instant Access Point 5.0.3.0-1.1.0.0 | User Guide Managing IAPs | 55