Dell PowerEdge 2900 Hardware Owner's Manual (PDF) - Page 32

Check the Time and Date settings. See, Unsupported CPU stepping - cpu upgrade

Get Dell PowerEdge 2900 PDF manuals and user guides View all Dell PowerEdge 2900 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

Table 1-7. System Messages (continued) Message Causes Corrective Actions The following DIMM pair is not compatible with the memory controller: DIMM x and DIMM y The specified DIMM(s) are incompatible with the system. Ensure that only Dell-qualified memory is used. Dell recommends purchasing memory upgrade kits directly from www.dell.com or your Dell sales agent to ensure compatibility. The following DIMMs are The specified DIMM(s) are not compatible: DIMM x and incompatible with the system. DIMM y Ensure that only ECC FBD1 memory is used. Dell recommends purchasing memory upgrade kits directly from www.dell.com or your Dell sales agent to ensure compatibility. Time-of-day clock stopped Faulty battery or faulty chip. See "Troubleshooting the System Battery" on page 122. Time-of-day not set please run SETUP program Incorrect Time or Date settings; faulty Check the Time and Date settings. See system battery. "Using the System Setup Program" on page 35. If the problem persists, replace the system battery. See "System Battery" on page 77. Timer chip counter 2 failed Faulty system board. See "Getting Help" on page 147. Unsupported CPU combination Unsupported CPU stepping detected Microprocessor(s) is not supported by Install a supported microprocessor or the system. microprocessor combination. See "Microprocessor" on page 89. Utility partition not available The key was pressed during POST, but no utility partition exists on the boot hard drive. Create a utility partition on the boot hard drive. See the CDs that came with your system. Warning! No microcode update loaded for processor n Microcode update failed. Update the BIOS firmware. See "Getting Help" on page 147. Warning: Embedded RAID firmware is not present! Embedded RAID firmware does not respond. See the RAID controller documentation for information about installing or updating the RAID firmware. Warning: Embedded RAID error! Embedded RAID firmware responds with an error. See "Troubleshooting a SAS or SAS RAID Controller Daughter Card" on page 130. See the RAID controller documentation for information about installing or updating the RAID firmware. 32 About Your System

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
32
About Your System
The following DIMM pair is
not compatible with the
memory controller: DIMM x
and DIMM y
The specified DIMM(s) are
incompatible with the system.
Ensure that only Dell-qualified memory
is used. Dell recommends purchasing
memory upgrade kits directly from
www.dell.com
or your Dell sales agent to
ensure compatibility.
The following DIMMs are
not compatible: DIMM x and
DIMM y
The specified DIMM(s) are
incompatible with the system.
Ensure that only ECC FBD1 memory is
used. Dell recommends purchasing
memory upgrade kits directly from
www.dell.com
or your Dell sales agent to
ensure compatibility.
Time-of-day clock stopped
Faulty battery or faulty chip.
See "Troubleshooting the System
Battery" on page 122.
Time-of-day not set -
please run SETUP program
Incorrect Time or Date settings; faulty
system battery.
Check the Time and Date settings. See
"Using the System Setup Program" on
page 35. If the problem persists, replace
the system battery. See "System Battery"
on page 77.
Timer chip counter 2
failed
Faulty system board.
See "Getting Help" on page 147.
Unsupported CPU
combination
Unsupported CPU stepping
detected
Microprocessor(s) is not supported by
the system.
Install a supported microprocessor or
microprocessor combination. See
"Microprocessor" on page 89.
Utility partition not
available
The <F10> key was pressed during
POST, but no utility partition exists
on the boot hard drive.
Create a utility partition on the boot
hard drive. See the CDs that came with
your system.
Warning! No microcode
update loaded for
processor
n
Microcode update failed.
Update the BIOS firmware. See "Getting
Help" on page 147.
Warning: Embedded RAID
firmware is not present!
Embedded RAID firmware does not
respond.
See the RAID controller documentation
for information about installing or
updating the RAID firmware.
Warning: Embedded RAID
error!
Embedded RAID firmware responds
with an error.
See "Troubleshooting a SAS or SAS
RAID Controller Daughter Card" on
page 130. See the RAID controller
documentation for information about
installing or updating the RAID
firmware.
Table 1-7.
System Messages
(continued)
Message
Causes
Corrective Actions