Dell PowerEdge 2900 Hardware Owner's Manual (PDF) - Page 97
Removing the SAS Controller Daughter Card - raid controller
View all Dell PowerEdge 2900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Figure 3-27. Replacing a SAS RAID Controller Daughter Card Battery 2 3 1 7 6 3 5 4 1 SAS RAID controller daughter 2 RAID battery cable card 4 routing hole for RAID battery 5 expansion-bay bracket cable 7 RAID battery 3 connector release tab 6 battery bay Removing the SAS Controller Daughter Card The following procedure applies to either a SAS controller or a SAS RAID controller daughter card. A SAS RAID controller daughter card is illustrated in Figure 3-28. 1 If applicable, disconnect the RAID battery cable from the controller card by releasing the tab on the cable connector on the daughter card and pulling the battery cable free. 2 Push outward on the plastic guide rails and gently pull up on the card edges until the card-edge connector clears the socket on the system board. See Figure 3-28. Installing System Components 97