Dell PowerEdge R7525 EMC Installation and Service Manual - Page 124
Installing the expansion card risers
View all Dell PowerEdge R7525 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 124 highlights
Next steps 1. Replace the expansion card riser. Installing the expansion card risers Prerequisites 1. Follow the safety guidelines listed in the Safety instructions on page 40. 2. Follow the procedure listed in Before working inside your system on page 41. 3. If removed, install the expansion cards into the expansion card risers. Steps 1. Holding the edges or the touch points, align the holes on the expansion card riser with the guides on the system board. 2. Lower the expansion card riser into place and press the touch points until the expansion card riser connector is fully seated on the system board connector. 3. Tighten the captive screws on the risers and system if any. NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence. Figure 83. Installing the expansion card riser (Riser 1) 124 Installing and removing system components