Dell PowerEdge R7525 EMC Installation and Service Manual - Page 150
Installing the internal USB card, Intrusion switch module, Removing the intrusion switch module
View all Dell PowerEdge R7525 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 150 highlights
Installing the internal USB card Prerequisites 1. Follow the safety guidelines listed in the Safety instructions on page 40. 2. Follow the procedure listed in Before working inside your system on page 41. 3. Remove the expansion card risers. Steps 1. Connect the USB key to the internal USB card. NOTE: Ensure to install the internal USB card in the IDSDM/USB card slot and not in the J_R3_PCIE_PWR connector slot. 2. Align the internal USB card with the connector on the system board and press firmly until the internal USB card is seated. Figure 116. Installing the internal USB card Next steps 1. Install the expansion card risers. 2. Follow the procedure listed in After working inside your system on page 41. 3. While booting, press F2 to enter System Setup and verify that the system detects the USB memory key. Intrusion switch module Removing the intrusion switch module Prerequisites 1. Follow the safety guidelines listed in the Safety instructions on page 40. 2. Follow the procedure listed in the Before working inside your system on page 41. 3. Remove the expansion card riser. 150 Installing and removing system components