Dell PowerEdge R7525 EMC Installation and Service Manual - Page 72
Installing the drive backplane, Installing and removing system components
View all Dell PowerEdge R7525 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
2. Insert the backplane into the guides and lower the backplane until the blue release tabs clicks into place. 3. Route the cables properly through the cable guide and connect the cables to the connector on the system board. Figure 52. Installing the drive backplane Next steps 1. Install the cooling fan cage assembly. 2. Install all the drives. 3. If removed, install the air shroud. 4. Install the drive backplane cover. 5. Connect the drive backplane cables to the connector on the system board. 6. Connect the drive backplane cables to the connector on the backplane. 7. Follow the procedure listed in After working inside your system on page 41. 72 Installing and removing system components
2.
Insert the backplane into the guides and lower the backplane until the blue release tabs clicks into place.
3.
Route the cables properly through the cable guide and connect the cables to the connector on the system board.
Figure 52. Installing the drive backplane
Next steps
1.
Install the cooling fan cage assembly
.
2.
Install all the drives
.
3.
If removed,
install the air shroud
.
4.
Install the drive backplane cover
.
5.
Connect the drive backplane cables to the connector on the system board.
6.
Connect the drive backplane cables to the connector on the backplane.
7.
Follow the procedure listed in
After working inside your system
on page 41.
72
Installing and removing system components