Dell PowerEdge R7525 EMC Installation and Service Manual - Page 145
M.2 SSD module, Removing the M.2 SSD module
View all Dell PowerEdge R7525 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 145 highlights
Figure 110. Installing the MicroSD card Next steps 1. Install the IDSDM module. 2. Follow the procedure listed in After working inside your system on page 41. M.2 SSD module Removing the M.2 SSD module Prerequisites 1. Follow the safety guidelines listed in the Safety instructions on page 40. 2. Follow the procedure listed in the Before working inside your system on page 41. 3. Remove the BOSS card. The BOSS card removal is similar to removing expansion card from the expansion card riser. Steps 1. Using the Phillips #1 screwdriver, remove the screws securing the M.2 SSD module to the BOSS card. 2. Pull the M.2 SSD module to disconnect from the BOSS card connector. NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence. Installing and removing system components 145