Dell PowerEdge R7525 EMC Installation and Service Manual - Page 138
Optional serial COM port, Removing the serial COM port
View all Dell PowerEdge R7525 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 138 highlights
Figure 102. Installing GPU on Riser 3 and Riser 4 Next steps 1. If removed, install the GPU air shroud . 2. Install the GPU air shroud top cover. 3. Install the full length expansion card riser. 4. Follow the procedure listed in After working inside your system on page 41. 5. Install any device drivers required for the card as described in the documentation for the card. Optional serial COM port Removing the serial COM port Prerequisites 1. Follow the safety guidelines listed in the Safety instructions on page 40. 2. Follow the procedure listed in the Before working inside your system on page 41. 3. Remove expansion card riser. 4. Disconnect the serial COM port cable from the connector on the rear I/O board. Steps 1. Open the latch on the expansion card riser and slide the serial COM port out of the expansion card riser. 138 Installing and removing system components