Dell PowerEdge T105 Hardware Owner's Manual (PDF) - Page 102
I/O panel cable to the CONTROL-PANEL connector, If applicable
View all Dell PowerEdge T105 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
5 Install the memory modules in the same sockets from which they were removed. See "Installing a Memory Module" on page 77. 6 Install the expansion cards and connect any cables. See "Installing an Expansion Card" on page 72. 7 Depending on your configuration, connect the following cables that you removed in "Removing the System Board" on page 100. See Figure 6-2. • Two power-supply cables to the POWER and POWER12V1 connectors • If applicable, diskette data cable to the FLOPPY connector • I/O panel cable to the CONTROL-PANEL connector • Processor cooling fan cable to the FAN1 connector • Card cage cooling fan cable to the FAN2 connector • SATA hard-drive data cable(s) to the SATA connector(s) • Intrusion switch cable from the INTRUSION connector 8 Close the system. See "Closing the System" on page 47. 9 Reconnect the system to the electrical outlet, and turn on the system. 102 Installing System Components